Gum graft diary: Day 5 & stitches

Sutures, sutures

The swelling is still hanging around but is not any worse. Still painful and sore in places where the stitches have been pulling particularly hard.  Graft is mostly pale pink and white; however, one tooth is particularly painful and the grafted area there is red.  

Even though the AlloDerm graft should ideally be completely covered by your own gum tissue, all the movement caused by the swelling can mean that parts of it get exposed.  You will notice this as white bits that stick out behind the pink gum tissue.  

This is OK - a little bit of exposure (maybe 1mm or so - you may even get away with more). Those exposed white bits can eventually be incorporated into your own gum tissue just like the rest, and you will see them gradually get pink as they become vascularised. Be gentle with them to increase their chances of survival, otherwise they can get knocked off - in which case they definitely won't be incorporated into the gums.  For AlloDerm patients, compliance with post-surgical care (soft diet!) is more important than for those with connective tissue grafts (grafts that used their own mouth tissue).

Today's theme: Stitches

Your stitches will go through a lot in the first few days while they cope with the swelling. The graft will pull against them and look puckered, with horribly uneven edges because the tissue is only held down in the places where the sutures have been placed.  As the swelling goes down, things may look uneven because the stitches aren't straining to hold such big puffy gums any more, and bits of the graft may become exposed. A few of the stitches may become loose as well.  

You will have two layers of stitches:

• Graft sutures: The lower layer of stitches holds the grafting material in place inside the pouch created for it underneath your gums. They will probably also put some glue-like material in there (Emdogain) that helps to stimulate tissue regeneration.
• Surface sutures: The second layer of stitches holds your gums over the graft. For alloderm, this is particularly important as the donor material should not be exposed to air.  

I was impressed with the method my surgeon used. She glued all of my teeth together at the top to create anchors that she could sling the stitches around. The glue is just a little dot of white/clear liquid between each tooth, a bit like composite filling material.  I think it looks really neat, and the stitches are straight and line up with the gaps between my teeth. 

I don't remember my surgeon back in 2012 doing this.  Maybe he did and I didn't notice, but the stitches certainly look nicer this time around. 

My loose stitch!

However, one of the bonds between my teeth popped off so the stitch is hanging loose. My periodontist asked me to send a photo - on this basis she said it was probably fine and I should just leave it.


She left the ends of the stitches quite long as well - apparently to give a bit more room for flexing if needed.  My previous surgeon back in 2012 cut the stitches short, so that seems to be a personal preference.